TOTAL PRO GF-30 1.75
€54.00
Tax included
TOTAL PRO GF-30 is impact-resistant glass-filled (30%) composite based on TPU with heat resistance up to 130°C or printing large gears, strong bodies, mechanically loaded parts, aerodynamic body kits for cars.
It has high chemical resistance to acid and alkali solutions, fats, oils, xylene, diesel fuel. Limited to gasoline, kerosene, acetone, dichloromethane.
DUE to low shrinkage (up to 0.8%), good interlayer adhesion and high abrasive resistance, TOTAL PRO GF-30 plastic will be an excellent alternative to composites based on polyamides. Perfectly amenable to drilling, threading.
For best results, it is recommended to dry for 2-3 hours before printing at a temperature of 60-70°C.
ATTENTION! Plastic is abrasive, it is recommended to print using a steel nozzle.
369918465098
10 Items
Data sheet
- Bed temperature
- 60-100°
- Density
- 1.45 g/cm3
- blowing
- if necessary 20-60%
- Nozzle temperature
- 230-250°C
- Print speed
- до 60 mm/s
- Filament feed
- 95-100%
- Nozzle diameter
- up to 0.4 mm (min)
- Min. layer height
- 0.15 mm
- Temperature resistance (min/max)
- от -50 до +130°С
- Bar diameter tolerance
- 0.03 mm
- Quantity per reel
- 250 m
- Shore D hardness
- 73
- Elongation at break
- 25%
- Tensile modulus
- 3000 MPa
- Maximum breaking strength
- 90 MPa
- Shrinkage in the manufacture of products
- 0.2-0.8%
Comments (0)
No customer reviews for the moment.
TOTAL PRO GF-30 is impact-resistant glass-filled (30%) composite based on TPU with heat resistance up to 130°C or printing large gears, strong bodies, mechanically loaded parts, aerodynamic body kits for cars.
It has high chemical resistance to acid and alkali solutions, fats, oils, xylene, diesel fuel. Limited to gasoline, kerosene, acetone, dichloromethane.
DUE to low shrinkage (up to 0.8%), good interlayer adhesion and high abrasive resistance, TOTAL PRO GF-30 plastic will be an excellent alternative to composites based on polyamides. Perfectly amenable to drilling, threading.
For best results, it is recommended to dry for 2-3 hours before printing at a temperature of 60-70°C.
ATTENTION! Plastic is abrasive, it is recommended to print using a steel nozzle.